We can go one step further with epoxy encapsulation: paint some parts before they get set up on the strongback. One of our kit builders is demonstrating this nicely in his Beg-Meil build. He lives in Billings, Montana and started the project this past summer. I advised him to layout all the parts from the kit and precoat them with 2-3 coats of epoxy. He took it further and precoated the bulkheads in his chosen interior color for the boat. This will be quite handy for the bulkheads that are trickier to reach.

You can imagine there is a little more work in tighter places if you do not precoat:

When you precoat with epoxy it is important to think about primary and secondary bonding and your timeline. If you precoat with System Three epoxy, you have a nice long 72-hour window where you get a primary (chemical) bond when you glue pieces together. In a small boat, you can probably put parts together in this timeline. However, with a bigger boat, since it will take longer, it is good to mask off areas that you want to keep as bare wood. This way when you glue those parts (e.g., the end-grain of the bulkheads and 3/4" or so along the sides for the fillet) you can get a primary bond. If you choose not to tape, you can rigorously sand the faying surfaces with 80-grit and get a very good bond, but it will be a secondary bond.

Read More..

I am a believer in epoxy encapsulation of wood; I wasn't always. Encapsulation entails coating the wood with multiple coats of epoxy, saturating the wood surface and building up a moisture-barrier. The moisture barrier is key for bilges and underbodies as it keeps water out of a laminate and maintains a more constant wood moisture content in timbers. Wood movement and ingress of water is what often gives wooden boats a bad name: high maintenance. Encapsulating forms a stable base for varnish and paint. We tell customers to expect a 10 year life for their paint. After 10 years of normal use they may need to do a fresh coat. That is as good as any fiberglass boat maintenance.

What convinced us of the merits of epoxy encapsulation was a visit to my friend Steven's house. He has a faering he built with his son that shows the effects of different plywoods and of epoxy coating wood.

You can see three panels in this Faering. The darker plank is Joubert Sapele faced Okoume (varnished), the middle strake is Okoume by Joubert, and the lower plank in the photo is Shelman Okoume. All planks are finished with a Behr spar varnish.

This is the same boat closer up to one of the tanktops. It is Joubert Okoume. The neighboring plank is Shelman Okoume. Both were varnished the same. The tank top is more degraded and molded than the plank. The tank top along the edge of the plank is perfectly clear. This strip was inadvertently epoxy coated when the squeeze out from the glue joint was spread during the clean up process. The same thing happened in the next photo: can you see where the epoxy is?

The results? It is clear that the epoxy coated areas of plywood are making the plywood much more durable and holding up much, much better. The sheer strake is probably holding up better because it is higher in the boat and receives less foot traffic and a lower angle of sunlight upon it. The middle strake and tank tops get more direct sunlight. But the different brands of plywood may have to do with the difference between planks made of Joubert vs Shelman. It is too bad Shelman went out of business. Clearly, Sapele holds up great and Steven made a good decision putting it in as the garboard. With that said, I have also seen Sapele planked boats flake and shed paint after many years and these were boats that were not epoxy coats.

The moral of the story: epoxy encapsulation is a good thing.

Read More..